Flashing Asus BW-16D1HT firmware

From Redump Wiki

Revision as of 20:40, 26 September 2024 by DopefishJustin (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Note: This wiki page is not complete. In the meantime, if you have issues please ask on the redump forum or VGPC discord.

Background

Some info on firmware downgrading the drive from the MakeMKV wiki is available here.

Known good LG/Asus BD ODDs were initially recommended to be flashed with Asus BW-16D1HT 3.02 (DE - Downgrade Enable), especially ODDs using PCB: JB8 2015.05.08 (Reference Image)) The 3.02 (DE) firmware supports Lead-in and the OpCode 0xf1[1][2] (normally used by Plextors to read the EEPROM, but in the case with Asus BW-16D1HT 3.02, it reads the cache) to read 1 sector[3] of Lead-out through cache.

On 2022-04-04, RibShark released a hacked version of the 3.10 firmware that enabled lead-out reading without using the cache.

Drive Models

Latest compatible official firmware version for some of the LG (HL-DT-ST) (rebadges/clones from Asus/Dell/HP) BD ODDs to support DiscImageCreator:

JB9 2015.09.03 ODDs:

  • LG (HL-DT-ST) WH16NS60: 1.00

JB8 2015.05.08 (Reference Image) ODDs:

  • Asus BC-12B1ST b (not yet tested)
  • Asus BC-12D2HT: 3.00
  • Asus BW-16D1HT: 3.02
  • Dell BH40N (07MM6C) (not yet tested)
  • HL-DT-ST BH50N (not yet tested)
  • LG (HL-DT-ST) BH14NS58: 1.00
  • LG (HL-DT-ST) BH16NS40: 1.02
  • LG (HL-DT-ST) BH16NS50 (not yet tested)
  • LG (HL-DT-ST) BH16NS55: 1.02
  • LG (HL-DT-ST) BH16NS58: 1.00
  • LG (HL-DT-ST) CH12NS40 (not yet tested)
  • LG (HL-DT-ST) UH12NS40: 1.00
  • LG (HL-DT-ST) WH14NS40: 1.02
  • LG (HL-DT-ST) WH16NS40: 1.02

JBC5 2012.05.02 (Reference Image) ODDs:

  • Asus BC-12B1ST b (not yet tested)
  • Asus BC-12D2HT (not yet tested)
  • Dell CH30N (0H3209) (not yet tested)
  • HP CH30L (A2HH) (not yet tested)
  • LG (HL-DT-ST) CH12NS30 (not yet tested)
  • LG (HL-DT-ST) CH30N (not yet tested)
  • LG (HL-DT-ST) UH12NS30 (not yet tested)

JB7 2011.11.17 (Reference Image) ODDs:

  • Asus BW-12B1ST a: 1.00
  • Asus BW-16D1HT (not yet tested)
  • HP BH40L (A2HH) (not yet tested)
  • HP BH40N (A2HH) (not yet tested)
  • LG (HL-DT-ST) BH14NS40: 1.00
  • LG (HL-DT-ST) BH16NS40: 1.03 (not yet added to DiscImageCreator)
  • LG (HL-DT-ST) BH16NS48 (not yet tested)
  • LG (HL-DT-ST) WH14NS40: 1.03 (not yet added to DiscImageCreator)
  • LG (HL-DT-ST) WH16NS40 (not yet tested)

Flashing Instructions

From here and below, this guide will focus only on JB8 2015.05.08 ODDs.

Requirements (before BW-16D1HT 3.11)

Some notes before you begin

  • After each file have been sucessfully flashed, it's a good idea to power cycle the ODD, either by disconnecting the SATA Power cable (wait at least 15 seconds before reconnecting) or by restarting the computer.
  • Specific instruction for GNU/Linux(-libre):

sudo wine ASUS_ODD_FW_Changer_-_FIRMWARE.exe

General Process

  • First, make sure MakeMKV is installed: https://www.makemkv.com/download/
  • Next, download the SDFtool Flasher (updated version) from this thread in the MakeMKV support forum: https://forum.makemkv.com/forum/viewtopic.php?t=22896
  • Run the SDFtool Flasher.exe, and it will open a dialog box. Select your ODD (drive) from the first drop-down menu.
  • Click the second drop-down menu, 'Please select a Firmware to Write,' and choose the firmware from the list below, depending on your drive/firmware combination.
  • If the drive currently has an encrypted firmware (e.g. 3.11, check the encrypted firmware list here), ensure there is a green checkmark next to 'Encrypted Firmware.' If there isn't, click on the Red X to make it a green checkmark.
  • Then click S T A R T and it will start flashing the firmware.

Model-specific instructions

ASUS BW-16D1HT with firmware 3.11

  • First Flash 3.10MK (SHA1: 303a00628bbf67ee8ba61757d61c370e45bd4451), then flash ASUS BW-16D1HT 3.02 (DE) (SHA1: 4130578520c024218a1d99f86311525a05bccb60).
  • Specific instruction for GNU/Linux(-libre) (first you would need to install MakeMKV): sudo makemkvcon f -f sdf_VERSION.bin -d /dev/srX rawflash enc -i ASUS-BW-16D1HT-3.10-WM01601-211901041014.bin


ASUS BW-16D1HT with firmware 3.00 --> 3.10

  • First flash 3.10MK (SHA1: 70762635c4bbd324c4f2095dc336acb3b0764919), then flash ASUS BW-16D1HT 3.02 (DE) (SHA1: 4130578520c024218a1d99f86311525a05bccb60).


LG (HL-DT-ST) WH14NS40 (SVC CODE: NS50) 1.00 --> 1.04


LG (HL-DT-ST) BH16NS55 (SVC CODE: NS55) with firmware 1.00(?) --> 1.04


LG (HL-DT-ST) WH16NS40 (SVC CODE: NS50) with firmware 1.00(?) --> 1.03 (1.02 (maybe earlier firmware versions as well) supports OpCode: 0xF1, no need to cross-flash)


Asus BC-12D2HT (PCB: JB8 2015.05.08) (Asus Label (circle) IDs: 90DD0230-B20000, 90DD0230-B20010) with firmware 3.00 --> 3.11 Note: these instructions need further testing before they can be recommended for use

  • A BD-ROM/DVD Rewriter cannot be cross-flashed to a Blu-ray Disc Rewriter or / UHD Blu-ray / DVD Writer with the ASUS Flash Tool, it needs to be flashed through DOS Flash
  • First flash 3.11MK (SHA1: 73ae04273b8af1fb49b6471f446f3385cba4acec), then flash ASUS BW-16D1HT 3.10MK (SHA1: 70762635c4bbd324c4f2095dc336acb3b0764919), and lastly flash ASUS BW-16D1HT 3.02 (DE) (SHA1: 4130578520c024218a1d99f86311525a05bccb60).
Retrieved from "http://wiki.redump.org/index.php?title=Flashing_Asus_BW-16D1HT_firmware"
Personal tools